Reaction wood in a woody plant is wood that forms in place of normal wood as a response to gravity, where the cambial cells are oriented other than vertically. It is typically found on branches and leaning stems. It is an example of mechanical acclimation in trees.[1][2]
Progressive bending and cracking would occur in parts of the tree undergoing predominantly tensile or compressive stresses were it not for the localised production of reaction wood, which differs from ordinary wood in its mechanical properties. Reaction wood may be laid down in wider than normal annual increments, so that the cross section is often asymmetric or elliptical. The structure of cells and vessels is also different, resulting in additional strength. The effect of reaction wood is to help maintain the angle of the bent or leaning part by resisting further downward bending or failure.
There are two different types of reaction wood, which represent two different approaches to the same problem by woody plants:
In most angiosperms reaction wood is called tension wood. Tension wood forms on the side of the part of the plant that is under tension, pulling it towards the affecting force (upwards, in the case of a branch). It has a higher proportion of cellulose than normal wood. Tension wood may have as high as 60% cellulose.[3]
In gymnosperms and amborella it is called compression wood. Compression wood forms on the side of the plant that is under compression, thereby lengthening/straightening the bend. Compression wood has a higher proportion of lignin than normal wood. Compression wood has only about 30% cellulose compared to 42% in normal softwood. Its lignin content can be as high as 40%.[3]
The controlling factor behind reaction wood appears to be the hormone auxin, although the exact mechanism is not clear. In a leaning stem, the normal flow of auxin down the tree is displaced by gravity and it accumulates on the lower side.[4] The formation of reaction wood may act in conjunction with other corrective or adaptive mechanisms in woody plants, such as thigomorphism (adaptive response to flexure) and gravitropism (the correction of, rather than the support of, lean) and the auxin-controlled balance of growth rates and growth direction between stems and branches. The term ‘adaptive growth' therefore includes, but is not synonymous with, the formation of reaction wood.
As a rule, reaction wood is undesirable in any structural application, primarily as its mechanical properties are different from normal wood: it alters the uniform structural properties of timber. Reaction wood can twist, cup or warp dramatically during machining. This movement can occur during the milling process, making it occasionally dangerous to perform certain operations without appropriate safety controls in place. For instance, ripping a piece of reaction wood on a table saw without a splitter or riving knife installed can lead to kick back of the stock. Reaction wood also responds to moisture differently from normal wood.
Traditionally, compression wood does have niche applications. For instance, hunters in north Eurasia and the American Arctic were known to harvest compression wood for bow staves, because the increased density and compression strength of this wood enabled them to make functional weapons out of tree species that would otherwise be unsuitable for this purpose, due to their low strength and low density.[5]
^Lonsdale, David (1999). Principles of Tree Hazard Assessment and Management. The Stationery Office. ISBN 0 11 753355 6.
^Jourez, Benoit. "Le bois de tension: 1 Définition et distribution dans l'arbe" (PDF). Ministère de la Région wallonne. Archived from the original (PDF) on 2 December 2017. Retrieved 12 February 2013.
^ abShigo, Alex (1986). A new tree biology dictionary. p. 90. ISBN 0-943563-05-4.
^Thomas, Peter (2000). Trees: Their Natural History. Cambridge University Press. ISBN 978-0-521-45963-1.
^Lepola, Marcus. "The use of compression wood in bows in the subarctic and arctic regions of Eurasia and America". Journal of Ethnology and Folkloristics.
Reactionwood in a woody plant is wood that forms in place of normal wood as a response to gravity, where the cambial cells are oriented other than vertically...
The reaction rate or rate of reaction is the speed at which a chemical reaction takes place, defined as proportional to the increase in the concentration...
Finkelstein reaction, named after the German chemist Hans Finkelstein, is a type of SN2 reaction (Substitution Nucleophilic Bimolecular reaction) that involves...
and experimentation. The chemical modification occurs through the reaction of wood polymers especially the free hydroxyl groups present in lignin and...
man's fertility. In other cases, such as in the wood mouse Apodemus sylvaticus, premature acrosome reactions have been found to cause increased motility in...
loads on the tissue. It has been shown that in reactionwood the MFA in S2-layer can vary. Tension wood has a low MFA, meaning that the microfibril is...
The Sabatier reaction or Sabatier process produces methane and water from a reaction of hydrogen with carbon dioxide at elevated temperatures (optimally...
in the direction of a design, with reactionwood soon closing the wounds to hold the curves. He proposed growing wood so that it constituted walls during...
other reactant, thus the faster the reaction. To make an analogy, for example, when one starts a fire, one uses wood chips and small branches — one does...
sophisticated builds, forward planks were cut from natural curved trees called reactionwood. Planks were installed unseasoned or wet. Partly worked stems and sterns...
A periosteal reaction is the formation of new bone in response to injury or other stimuli of the periosteum surrounding the bone. It is most often identified...
gravitropism to resume vertical growth, thereby taking on a curved shape. The reactionwood formed by this process can be studied using dendrochronology using annual...
February 8, 2019. Mamo, Heran (December 3, 2019). "Evan Rachel Wood Had a Very Good Reaction to Her Billboard Hot 100 Chart Debut". Billboard. Retrieved...
processes are: Combustion of fuels such as wood, coal and oil/petroleum The thermite reaction The reaction of alkali metals and other highly electropositive...
colored wood is used for carpentry. The tree can be planted for shade. Yields of pods may be 45–135 kg per tree per year. Krummholz Reactionwood National...
curve individual trunks and branches in the direction of a design, with reactionwood soon closing the wounds to hold the curve. He envisioned growing trees...
problems. Food, insect stings, and medications are common causes of severe reactions. Their development is due to both genetic and environmental factors. The...
Methanol (also called methyl alcohol and wood spirit, amongst other names) is an organic chemical compound and the simplest aliphatic alcohol, with the...
carbonization of wood in an industrial setting usually requires a temperature above 280 °C, which frees up energy and hence this reaction is said to be exothermic...
Knocking on wood (also phrased touching wood or touch wood) is an apotropaic tradition of literally touching, tapping, or knocking on wood, or merely stating...
Carbothermic reactions involve the reduction of substances, often metal oxides (O2-), using carbon (C) as the reducing agent. The reduction is usually...
the well known exothermic reaction which takes place in charcoal burning. At this stage evolution of the by-products of wood carbonization starts. These...
Derecho Krummholz: crooked, stunted trees Microburst: sinking air Reactionwood Allen, Douglas C. (1999). "Identifying Trees at Risk from Ice and Wind"...
capillary structure of the chips and low temperature chemical reactions with the wood begin. A good impregnation is important to get a homogeneous cook...
Engineered wood, also called mass timber, composite wood, human-made wood, or manufactured board, includes a range of derivative wood products which are...
Global Information