Mechanism for converting reciprocating motion to rotation
For other uses, see Crankshaft (disambiguation).
A crankshaft is a mechanical component used in a piston engine to convert the reciprocating motion into rotational motion. The crankshaft is a rotating shaft containing one or more crankpins,[1] that are driven by the pistons via the connecting rods.[2]
The crankpins are also called rod bearing journals, and they rotate within the "big end" of the connecting rods.
Most modern crankshafts are located in the engine block. They are made from steel or cast iron, using either a forging, casting or machining process.
^"How the crankshaft works – All the details". How a Car Works. Retrieved 27 August 2022.
^"Definition of CRANKSHAFT". Merriam-Webster Dictionary.
A crankshaft is a mechanical component used in a piston engine to convert the reciprocating motion into rotational motion. The crankshaft is a rotating...
petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the...
(accessory drive) end of the crankshaft of an internal combustion engine to counter torsional and resonance vibrations from the crankshaft. This device must be...
eight-cylinder piston engine in which two banks of four cylinders share a common crankshaft and are arranged in a V configuration. The first known V8 was the Antoinette...
cross-plane is a crankshaft design for piston engines with a 90° angle (phase in crank rotation) between the crank throws. The crossplane crankshaft is the most...
An undercut crankshaft is a form of crankshaft for piston engines, where the overall length of the crankshaft is shortened by overlapping the main bearings...
the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. The...
engine is a six-cylinder piston engine where the cylinders share a common crankshaft and are arranged in a V configuration. The first V6 engines were designed...
cylinder to the crankshaft via a piston rod and/or connecting rod. In a pump, the function is reversed and force is transferred from the crankshaft to the piston...
block and the sump houses a crankshaft that converts the reciprocating motion of the pistons to rotational motion. The crankshaft is held in place relative...
A main bearing is a bearing in a piston engine which holds the crankshaft in place and allows it to rotate within the engine block. The number of main...
In a piston engine, the crankcase is the housing that surrounds the crankshaft. In most modern engines, the crankcase is integrated into the engine block...
engines are usually designed with the cylinders in lines parallel to the crankshaft. It is called a straight engine (or 'inline engine') when the cylinders...
coplanar, the connecting rods cannot all be directly attached to the crankshaft unless mechanically complex forked connecting rods are used, none of which...
valve gear was usually by an eccentric, which turned the rotation of the crankshaft into reciprocating motion of the valve gear, normally a slide valve. Camshafts...
crankcase, tunnel crankshaft or disc-webbed crankshaft is a design feature of a piston engine where the main bearings that support the crankshaft within the...
the engine's crankshaft axis is perpendicular to the direction of travel. In a longitudinal engine configuration, the engine's crankshaft axis is parallel...
from the crankshaft by gears, chains or a toothed belt (often the timing belt) that also drives the camshaft. It rotates at half crankshaft speed in a...