Cooling load is the rate at which sensible and latent heat must be removed from the space to maintain a constant space dry-bulb air temperature and humidity.[1][2] Sensible heat into the space causes its air temperature to rise while latent heat is associated with the rise of the moisture content in the space. The building design, internal equipment, occupants, and outdoor weather conditions may affect the cooling load in a building using different heat transfer mechanisms.[1] The SI units are watts.
^Kreider, Jan F.; Curtiss, Peter S.; Rabl, Ari (2010). Heating and cooling of buildings : design for efficiency (Rev. 2nd ed.). Boca Raton: CRC Press/Taylor & Francis. ISBN 978-1-4398-1151-1.
Coolingload is the rate at which sensible and latent heat must be removed from the space to maintain a constant space dry-bulb air temperature and humidity...
estimating the coolingload or heating load of a building. It was introduced in the 1979 ASHRAE handbook. The CLTD/CLF/SCL (coolingload temperature difference/cooling...
index UFAD coolingload ratio (UCLR), which is defined by the ratio of the peak coolingload calculated for UFAD to the peak coolingload calculated for...
presence of the raised floor affects the zone coolingload profile and tends to increase the peak coolingload. When carpeting is present the negative impact...
evaporative cooling can still take advantage of the evaporative cooling process without increasing humidity. Passive evaporative cooling strategies can...
forced air or water cooling system. The device usually also includes instruments for metering, load control, and overload protection. Load banks can either...
percentage of the total coolingload that can be attributed to the sensible load. Defined to be sensible coolingload divided by the total load, expressed as a...
District cooling is the cooling equivalent of district heating. Working on broadly similar principles to district heating, district cooling delivers chilled...
Ventilative cooling is the use of natural or mechanical ventilation to cool indoor spaces. The use of outside air reduces the coolingload and the energy...
controls. Energy savings in DOAS/radiant ceiling cooling panel system can by linked to: cooling coil load reduction, chiller energy reduction, pumping energy...
energy storage projects Smart grid Vehicle-to-grid Turbine inlet air coolingLoad following power plant Renewable and Efficient Electric Power Systems...
or "solar-powered air conditioning", refers to any air conditioning (cooling) system that uses solar power. This can be done through passive solar design...
A cooling tower is a device that rejects waste heat to the atmosphere through the cooling of a coolant stream, usually a water stream, to a lower temperature...
battery. It can be used either for heating or for cooling, although in practice the main application is cooling.[citation needed] It can also be used as a temperature...
plants, the heating and coolingloads of buildings, climate modeling and weather forecasting, passive daytime radiative cooling applications, and space...
radiative cooling (PDRC) is a zero-energy building cooling method proposed as a solution to reduce air conditioning, lower urban heat island effect, cool human...
or cooling pond instead of a cooling tower. This single pass or once-through cooling system can save the cost of a cooling tower and may have lower energy...
system is operating. A cooling anticipator generates a small amount of additional heat to the sensing element while the cooling appliance is not operating...
gain prevention) or by removing heat from the building (natural cooling). Natural cooling utilizes on-site energy, available from the natural environment...
and after the dive. Wind chill. Increased convective cooling by ambient air Evaporative cooling in air Breathing gas temperature, density, specific heat...
Deep water source cooling (DWSC) or deep water air cooling is a form of air cooling for process and comfort space cooling which uses a large body of naturally...
temperature of the gas in the low temperature side. Therefore, for the same coolingload, gas refrigeration cycle machines require a larger mass flow rate, which...
with air based cooling systems. Radiant cooling systems potentially offer reductions in cooling energy consumption. The latent loads (humidity) from...
engine cooling uses either air or liquid to remove the waste heat from an internal combustion engine. For small or special purpose engines, cooling using...
must be used to operate the cooling mechanism, far more than active liquid cooling. The additional components of the cooling mechanism also add weight to...
Global Information