Standard for serial communication between devices without host computer
This article has multiple issues. Please help improve it or discuss these issues on the talk page. (Learn how and when to remove these template messages)
This article's lead section may be too short to adequately summarize the key points. Please consider expanding the lead to provide an accessible overview of all important aspects of the article.(November 2020)
This article's use of external links may not follow Wikipedia's policies or guidelines. Please improve this article by removing excessive or inappropriate external links, and converting useful links where appropriate into footnote references.(January 2024) (Learn how and when to remove this message)
This article may be too technical for most readers to understand. Please help improve it to make it understandable to non-experts, without removing the technical details.(January 2024) (Learn how and when to remove this message)
(Learn how and when to remove this message)
A controller area network (CAN bus) is a vehicle bus standard designed to allow microcontrollers and devices to communicate with each other. It is a message-based protocol, designed originally for multiplex electrical wiring within automobiles to save on copper, but it can also be used in many other contexts. For each device, the data in a frame is transmitted serially but in such a way that if more than one device transmits at the same time, the highest priority device can continue while the others back off. Frames are received by all devices, including by the transmitting device.
A controller area network (CANbus) is a vehicle bus standard designed to allow microcontrollers and devices to communicate with each other. It is a message-based...
vehicles. CAN FD is an extension to the original CANbus protocol that was specified in ISO 11898-1. CAN FD is the second generation of CAN protocol developed...
Single main means no bus arbitration (and associated failure modes) - unlike CAN-bus Transceivers are not needed - unlike CAN-bus Signals are unidirectional...
A bus (contracted from omnibus, with variants multibus, motorbus, autobus, etc.) is a road vehicle that carries significantly more passengers than an...
the term bus depot can also be used to refer to a bus station, it can also refer to a bus garage. A bus station is larger than a bus stop, which is usually...
technologies and the facilities implemented in the car grew, while the CANbus was too expensive to implement for every component in the car. European...
control character in the C0 control code set CANbus, controller area network bus, a type of microcontroller bus designed for vehicles Computer-assisted notetaking...
installed in a vehicle which has UDS services enabled. In contrast to the CANbus protocol, which only uses the first and second layers of the OSI model...
communication with the CANbus is therefore done analogously to the use of the Internet Protocol via sockets. Fundamental components of SocketCAN are the network...
A shuttle bus is a bus that travels a shorter route in comparison to most bus routes. Typically, shuttle buses travel in both directions between two points...
on, and harmonized with, the SAE J1939 protocol (which is based on the CANbus). Official maintenance of ISO 11783 is done by ISO TC 23 / SC 19 / WG 1...
return an appropriate response (or error message). A serial bus for Modbus over Serial Line can have a maximum of 247 slaves communicating with 1 master...
FlexCAN is an embedded network architecture that extends Controller Area Network (CAN). It was designed by Dr. Juan Pimentel at Kettering University....
Bus rapid transit (BRT), also referred to as a busway or transitway, is a bus-based public transport system designed to have much more capacity, reliability...
ISO 11992 is a CAN based vehicle bus standard by the heavy duty truck industry. It is used for communication between the tractor and one or more trailers...
of a CAN-frame is known as communication object identifier, or COB-ID. In case of a transmission collision, the bus arbitration used in the CANbus allows...
transit bus (also big bus, commuter bus, city bus, town bus, urban bus, stage bus, public bus, public transit bus, or simply bus) is a type of bus used in...
An articulated bus, also referred to as a slinky bus, bendy bus, tandem bus, vestibule bus, stretch bus, or an accordion bus, is an articulated vehicle...
supplementary information exists for the connector: CANbus communication according to ISO 11992. The CANbus is not necessary for the ABS to work which means...
A bus stop is a place where buses stop for passengers to get on and off the bus. The construction of bus stops tends to reflect the level of usage, where...