In turbocharged internal combustion engines, a boost controller is a device sometimes used to increase the boost pressure produced by the turbocharger. It achieves this by reducing the boost pressure seen by the wastegate.
a boostcontroller is a device sometimes used to increase the boost pressure produced by the turbocharger. It achieves this by reducing the boost pressure...
factory boost levels, such as bleeding air off the wastegate diaphragm to 'fool' it into staying closed longer, or installing a boostcontroller. To prevent...
settings for the Biturbo, and was known as the Maserati Automatic BoostController (MABC). The APC allowed a higher compression ratio (initially, 8.5:1...
Industry Controller Naming - Is the naming of controllers where the logical thought of the controller's name implies the system the controller is responsible...
electronic boostcontroller. Standard wastegates have one port for attaching the boost control line from the charge air supply line or boost control solenoid...
fashioned term condenser by mechanics. As well as suppressing arcing, it helps boost the coil output by creating a resonant LC circuit with the coil windings...
naturally-aspirated engines; however, turbocharging and supercharging are currently a very popular way of boosting power output for a number car marques....
its surrounding atmosphere; however a forced induction engine produces "boost", whereby the air pressure is higher than the surrounding atmosphere. Since...
enters the cylinders. Engines using port fuel-injection typically run lower boost pressures and/or compression ratios than direct injected engines because...
pressure decreasing the manifold pressure by reducing the throttle opening or boost pressure reducing the load on the engine Because pressure and temperature...
introduction of Saab's Automatic Performance Control (APC), a.k.a. boostcontroller for the Turbo models. The APC employed a knock sensor, allowing the...
of 335 km/h (208 mph). A manual boostcontroller, located beneath the steering wheel, could be used to adjust the boost pressure from 0.7 bar to 1.5 bar...