International Telecommunication Union (Radio Regulations)
World Radiocommunication Conference
Radiation sources / regions
Boresight
Focal cloud
Ground plane
Main lobe
Near and far field
Side lobe
Vertical plane
Characteristics
Array gain
Directivity
Efficiency
Electrical length
Equivalent radius
Factor
Friis transmission equation
Gain
Height
Radiation pattern
Radiation resistance
Radio propagation
Radio spectrum
Signal-to-noise ratio
Spurious emission
Techniques
Beam steering
Beam tilt
Beamforming
Small cell
Bell Laboratories Layered Space-Time (BLAST)
Massive Multiple-input multiple-output (MIMO)
Reconfiguration
Spread spectrum
Wideband Space Division Multiple Access (WSDMA)
v
t
e
In electromagnetics, the antenna factor (AF, units: m−1, reciprocal meter) is defined as the ratio of the electric field E (units: V/m or μV/m) to the voltage V (units: V or μV) induced across the terminals of an antenna:
If all quantities are expressed logarithmically in decibels instead of SI units, the above equation becomes
The voltage measured at the output terminals of an antenna is not the actual field intensity due to actual antenna gain, aperture characteristics, and loading effects.[1][clarification needed]
For a magnetic field, with units of A/m, the corresponding antenna factor is in units of A/(V⋅m). For the relationship between the electric and magnetic fields, see the impedance of free space.
For a 50 Ω load, knowing that PD Ae = Pr = V2/R and E2= PD ~ 377PD (E and V noted here are the RMS values averaged over time), the antenna factor is developed as:
Where
Ae = (λ2G)/4π : the antenna effective aperture
PD is the power density in watts per unit area
Pr is the power delivered into the load resistance presented by the receiver (normally 50 ohms)
G: the antenna gain
is the magnetic constant
is the electric constant
For antennas which are not defined by a physical area, such as monopoles and dipoles consisting of thin rod conductors, the effective length (units: meter) is used to measure the ratio between voltage and electric field.
^Electronic Warfare and Radar Systems - Engineering Handbook (4th ed.). US Naval Air Warfare Center Weapons Division. 2013. p. 192.
In electromagnetics, the antennafactor (AF, units: m−1, reciprocal meter) is defined as the ratio of the electric field E (units: V/m or μV/m) to the...
An antenna array (or array antenna) is a set of multiple connected antennas which work together as a single antenna, to transmit or receive radio waves...
In antenna theory, a phased array usually means an electronically scanned array, a computer-controlled array of antennas which creates a beam of radio...
and telecommunications a dipole antenna or doublet is one of the two simplest and most widely-used types of antenna; the other is the monopole.[full...
capacitive reactance of the antenna and inductive reactance of the required loading coil do not decrease, the Q factor of the antenna increases; it acts electrically...
meter: measure of the antenna effective area. dBm−1 dB(m−1) – decibel relative to reciprocal of meter: measure of the antennafactor. dB‑Hz dB(Hz) – bandwidth...
directional antenna or beam antenna is an antenna which radiates or receives greater radio wave power in specific directions. Directional antennas can radiate...
the array factor is a measure of how much a specific characteristic changes because of the grouping. This phenomenon is observed when antennas are grouped...
A loop antenna is a radio antenna consisting of a loop or coil of wire, tubing, or other electrical conductor, that for transmitting is usually fed by...
distributed antenna elements rather than a single antenna, then the total radiated power is reduced by approximately a factor N1–n/2 and the power per antenna is...
hypothetical isotropic radiator is 1, or 0 dBi. An antenna's directivity is greater than its gain by an efficiency factor, radiation efficiency. Directivity is an...
viewed from points near the direction of maximum radiation. Antenna effective length Antennafactor This article incorporates public domain material from...
A spiral antenna is a type of radio frequency antenna shaped as a spiral,: 14‑2 first described in 1956. Archimedean spiral antennas are the most popular...
In physics and engineering, the quality factor or Q factor is a dimensionless parameter that describes how underdamped an oscillator or resonator is. It...
(Ohm) output. However the impedance of any antenna normally varies, depending on the frequency and other factors, and consequently alters the signal impedance...
A parabolic antenna is an antenna that uses a parabolic reflector, a curved surface with the cross-sectional shape of a parabola, to direct the radio...
A television antenna (TV aerial) is an antenna specifically designed for use with a television receiver (TV) to receive over-the-air broadcast television...
Antenna diversity, also known as space diversity or spatial diversity, is any one of several wireless diversity schemes that uses two or more antennas...
A turnstile antenna, or crossed-dipole antenna, is a radio antenna consisting of a set of two identical dipole antennas mounted at right angles to each...
In the field of antenna design the term radiation pattern (or antenna pattern or far-field pattern) refers to the directional (angular) dependence of...
A fractal antenna is an antenna that uses a fractal, self-similar design to maximize the effective length, or increase the perimeter (on inside sections...
intensity. The latter factor is quantified by the antenna gain, which is the ratio of the signal strength radiated by an antenna in its direction of maximum...
The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. It takes its name from...