Residual bit error rate information

The residual bit error rate (RBER) is a receive quality metric in digital transmission, one of several used to quantify the accuracy of the received data...

Error rate, meaning the frequency of errors, can have the following uses: Bayes error rate Bit error rate Per-comparison error rate Residual bit error...

The GPS makes corrections for receiver clock errors and other effects but there are still residual errors which are not corrected. GPS receiver position...

Reed–Solomon error correction codes that steepen the overall bit-error-rate curve and produce extremely low residual undetected error rates. Both Viterbi...

synchronization between compressor and decompressor, except for very high residual bit error rates. The notion of compressor/decompressor states is orthogonal to...

frame rate of 30/1.001 = 29.970029 frame/s. The difference is one additional NTSC frame per 1,000,000 timecode frames, a residual timing error of 1.0 ppm...

Since one cannot completely ignore the bit error-rate of the medium, each switching node needs to implement error detection to avoid wasting bandwidth due...

good video quality at substantially lower bit rates than previous standards (i.e., half or less the bit rate of MPEG-2, H.263, or MPEG-4 Part 2), without...

residual at some sample K must return to the initial value ϕ 0 {\displaystyle \phi _{0}} . The interval K is referred to as the grand repetition rate...

video quality at the same bit rate. It supports resolutions up to 8192×4320, including 8K UHD, and unlike the primarily 8-bit AVC, HEVC's higher fidelity...

recursion subject to round-off error accumulation, and is thus recommended for an occasional evaluation. A norm of the residual is typically used for stopping...

increasing the bit error rate requires a higher signal-to-noise ratio (SNR) by increasing signal energy, reducing noise, or both. If data rates beyond those...

tend to have a small residual packet loss rate caused by low-probability statistical congestion events and amplification of bit errors in the underlying...

will compute the differences between them. Those residual values are known as the prediction error and need to be transformed and sent to the decoder...

Since TDM data is delivered at a constant rate over a dedicated channel, the native service may have bit errors but data is never lost in transit. All PSNs...

followed by forty zeroes in HD); this bit pattern is not legal anywhere else within the data payload. Several bit rates are used in serial digital video signal:...

rate is at least one bit per symbol, significant redundancy may be produced because the smooth regions in an image can be encoded at less than 1 bit per...

used to store the DRAM data bits. These effects have been reduced today by using purer packaging materials, and employing error-correcting codes to detect...

is affected and the error does not propagate to other parts of the message. This property is useful when the transmission error rate is high; however, it...

weights receives an update proportional to the partial derivative of the error function with respect to the current weight. The problem is that as the...

SCSI-2 have the option of parity bit error checking. Starting with SCSI-U160 (part of SCSI-3) all commands and data are error checked by a cyclic redundancy...

of bits required to transmit the residual error signal. As such, it is often used in video compressors, either as a way to drive and estimate rate explicitly...

number of codecs with even lower bit rates have been demonstrated. Codec2, which operates at bit rates as low as 450 bit/s, sees use in amateur radio. NATO...