Multiple electronic amplifiers can be connected such that they drive a single floating load (bridge) or a single common load (parallel), to increase the amount of power available in different situations. This is commonly encountered in audio applications.
and 25 Related for: Bridged and paralleled amplifiers information
applications. Bridged or paralleled modes of working, normally involving audio power amplifiers, are methods of using a two or more identical amplifiers to drive...
contain several discrete buffer amplifiers. For example, a hex buffer is a single package containing 6 buffer amplifiers, and an octal buffer is a single...
and power ratings for guitar amplifiers, from small, lightweight "practice amplifiers" with a single 6-inch speaker and a 10-watt amp to heavy combo amps...
to noticeable deviations from ideal operational amplifier behavior. For example, operational amplifiers have a specified power supply rejection ratio that...
amplifiers to compete with existing amplifiers, the most notable of which at the time were the Fender amplifiers imported from the United States. Jim...
amount of amplifier power. Even though tube amplifiers produce more heat than solid state amplifiers, few manufacturers of tube amplifiers include cooling...
requires paralleling output tubes, and in practice, V1 and V2 are not single triodes, but massive banks of paralleled triodes. Simple OTL amplifiers, for...
(output impedance) of the power amplifier. This can be calculated from the ZL of the loudspeaker (typically 2, 4, or 8 ohms) and the given value of the damping...
6505 amplifiers.[citation needed] The Bandit amp series are solid-state combo guitar amplifiers. The Bandit amplifiers were introduced in 1980 and remain...
(such as < 0.1 ohm in typical semiconductor amplifiers), for improved speaker damping. For vacuum tube amplifiers, impedance-changing transformers are often...
approximation improves as crosstalk weakens and harmonic number increases. Over time, nonlinear high gain amplifiers have replaced nonlinear electro-mechanical...
of a bridged T network. This term is often used to mean a Zobel network, sometimes incorrectly when the circuit implementation is not a bridged T. Parts...
high-impedance amplifiers (such as vacuum tubes, field effect transistor amplifiersand op-amps) is often specified as a resistance in parallel with a capacitance...
amplifiers with the exception of the Player and Performance Pack practice amplifiers, available only in Epiphone's starter packages. These Amplifiers...
explicit level detectors and gain-controlled amplifiers. One of the most common gain-stabilized circuits is the Wien bridge oscillator. In this circuit...
play solos like the saxophone and trumpet. The development of guitar amplifiers, which contained a power amplifierand a loudspeaker in a wooden cabinet...
which use two-port amplifying active elements such as transistors and operational amplifiers, linear oscillators can also be built using one-port (two terminal)...
box, and the DI signal would be mixed through a mixing console into a main or monitor mix. Some instrument amplifiers, particularly bass amplifiers, contain...
resistance filters are the bridged-T and its variants, all described in the Zobel network article; Bridged-T topology Balanced bridged-T topology Open-circuit...
Cube series and its clones), but did not see much use in commercial audio power amplifiers. The Accuphase current-feedback power amplifiers of the 1990s...
differential amplifiers. The top differential amplifier, whose output is referenced to ground potential, has unitary gain. The bottom differential amplifier, whose...
Bad Steben, Germany, founded by Peter Diezel and Peter Stapfer, that builds high-end guitar amplifiers. The company was established in 1992. ^ 6L6, EL34...
Global Information