Can Starlink cable be buried? Yes, but you need to be aware of the limitations of this cable installation method. Usually, a dishy cable is used for this purpose. This type of cable is more resistant to weather, UV rays, and direct burial. This type of cable also has a heavier gauge. Because Starlink runs a lot of power, the required wire gauge also increases. In order to avoid splicing, you should dig a trench at least a foot deep.
To install the Starlink Volcano Mount, you need to pour concrete on the pole and wait for it to harden. Once the concrete is hardened, you must insert the cable into the ground and wait for it to set. Make sure that the Starlink is not lying face down, and press the snap buttons. Moreover, if you want to bury the cable underground, you must select a burial-rated one.
Aside from ensuring that the Starlink Volcano Mount is installed properly, you must also follow proper installation procedure. You should install the pole in an upright position, and then press the snap buttons. You should choose a suitable cable for the underground installation. To make sure that the cable is installed correctly, check the installation manual carefully. If the instructions are not clear, contact the manufacturer. You should not bury the Starlink Volcano Mount installers.
If you are not satisfied with the cable’s installation, you can use another one. You can also install the Starlink Volcano Mount on top of your existing pole. After installation, make sure that the pole’s top position does not rotate. If you do not want the pole to tilt, you can use another type of mounting for the Starlink. This type of mount allows you to install the router and power supply on the same pole.
While it is possible to install your Starlink Volcano Mount outside, you must make sure that you follow the instructions provided by the manufacturer. After installation, make sure you install the cable in a location where it will not be damaged. You should also use an approved trenching service. If you don’t want to install the dish on top of your pole, you can install the pole in the ground. But make sure you choose the correct mounting solution.
It is possible to install the Starlink Volcano Mount, but you must make sure that the pole is upright when you’re installing it. Ensure that you’ve poured the concrete before starting the installation. After the concrete dries, you should ensure that the pole does not have any trees or other objects blocking the satellite’s line of sight. Finally, you need to be certain that the location you’re using has a CAT to fiber converter.
Depending on where you’re burying the Starlink Volcano Mount, you’ll have to take care of the installation process. Afterwards, you should depress the snap buttons on the cable and then place the antenna inside the concrete. After the concrete has set, you should check for any visible damages and then install the Starlink Volcano Mount. If the antenna is not buried, make sure it’s installed upright and that it’s rated for burial.
In addition to PoE, the Starlink Volcano mount should have its own power source. This is the most important part of the installation. Otherwise, you’ll have to install it on the ground. Then, you’ll have to install the cable in the ground and connect it to the satellite. The Starlink Volcano Mount needs to be installed in the upright position. If the cable is buried, it must be installed in the proper direction, but not in the exact same direction.
Although Starlink’s line-of-sight connection is critical for its operation, a tree that blocks the satellite’s line-of-sight will sabotage the signal. Luckily, the cable is designed to be buried underground and should not be visible from the ground. If the Starlink is installed in a residential area, you should consider using a CAT-to-fiber converter, so you don’t have to worry about the installation of the cable.